The network information page will be printed. Press and hold the button until the power lamp flashes 6 times, and then release it.Load a sheet of A4 or Letter-sized plain paper.Make sure that your printer is turned on.To confirm that your printer is successfully connected to your wireless network, you can print out the network settings of your printer if you wish: When the printer has successfully made a connection to your wireless network, the blue lamp will stop flashing and remain lit. The (blue) Wi-Fi lamp on the printer will continue flashing while searching for, or connecting to the access point. Make sure that this button starts to flash blue and then go to your access point and press the button within 2 minutes. For exact details regarding pressing the WPS button, please refer to the access point manual.
Press and hold the button on the front of the printer for a few seconds.Make sure that the printer is turned on.Most WPS enabled access points to use this protocol. Your network must be using the WPA (Wi-Fi Protected Access) or WPA2 security protocol.If the WPS push button is not available please use the instructions on the Standard Connection Method tab. Please check with your device’s user guide for details. The access point must have a physical WPS push button available.
WPS Connection Methodīefore we start, there are some conditions that must be met in order to use the WPS push button method: If your router does not support WPS we have provided alternative instructions to get your PIXMA iP7250 connected so please select the ‘Standard Connection Method’ tab below.